[Two Women] GRBL Setting and parts

• Stepper motor: 17Y - High Torque (Square) Stepper Motors
http://www.anaheimautomation.com/products/stepper/stepper-motor-item.php?sID=12&pt=i&tID=75&cID=19

Screen Shot 2014-02-21 at 6.10.52 PM

• Solenoid - 36v
https://www.sparkfun.com/products/10391


Configuring Grbl v0.8
https://github.com/grbl/grbl/wiki/Configuring-Grbl-v0.8

• Grbl pins
Screen Shot 2014-02-16 at 8.54.57 PM
* Installation
http://wiki.roberttwomey.com/GRBL#To_compile_GRBL_and_upload_to_the_Arduino

2/21/2014(Fri)
Gcode: $0=137.537 (x, step/mm) //punching position
Gcode: $1=250.000 (y, step/mm) //paper
Gcode: $2=250.000 (z, step/mm) //no z
Gcode: $3=10 (step pulse, usec)
Gcode: $4=250.000 (default feed, mm/min)
Gcode: $5=500.000 (default seek, mm/min)
Gcode: $6=192 (step port invert mask, int:11000000)
Gcode: $7=25 (step idle delay, msec)
Gcode: $8=10.000 (acceleration, mm/sec^2)
Gcode: $9=0.050 (junction deviation, mm)
Gcode: $10=0.100 (arc, mm/segment)
Gcode: $11=25 (n-arc correction, int)
Gcode: $12=3 (n-decimals, int)
Gcode: $13=1 (report inches, bool)
Gcode: $14=1 (auto start, bool)
Gcode: $15=0 (invert step enable, bool)
Gcode: $16=0 (hard limits, bool)
Gcode: $17=1 (homing cycle, bool)
Gcode: $18=0 (homing dir invert mask, int:00000000)
Gcode: $19=25.000 (homing feed, mm/min)
Gcode: $20=250.000 (homing seek, mm/min)
Gcode: $21=100 (homing debounce, msec)
Gcode: $22=1.000 (homing pull-off, mm)

• to start up program to the inside of the microprocessor
"$N0=G20G90\n"